PROCESS MARKET: REGENERATIVE TURBINE
Regenerative Turbine pumps are tight tolerance pumps with an impeller that generates a higher head performance than comparably sized centrifugal pumps. Ideal for thinner fluids, the Nikuni pumps have modular inlet and outlet port configurations for flexible installation into OEM equipment.
Nikuni utilizes a fixed impeller. Many competitors use a floating impeller, which relies on good hydraulic conditions to balance the impeller centrally. When good conditions are not present (startup, shut-down, open flow, dead head, starved inlet, etc) a floating impeller will wear and ultimately reduce seal life and performance. Nikuni fixed impeller G and D series pumps do not have impeller wear and are more efficient because they are closer tolerance to the pump body.
G Series Regenerative Turbine Pump
G Series Pumps
Models: 4 sizes, medium and high pressure options
Construction: 313 SS, Carbon v SiC seal w Viton
Flow: 30 GPM Max
Pressure: 460 Ft
Motors: 1 or 3 ph, UL Listed, 1/2-3 HP
G&D Bruchure
G&D Video
GNL-Series Family Curve-60 Hz
GNH Series Family Curve-60 Hz
15DKN-Performance Curve-60 Hz
15DKN-Performance Curve-50 Hz
20DKN-Performance Curve-60 Hz
20DKN-Performance Curve-50 Hz
25DKN-Performance Curve-60 Hz
25DKN-Performance Curve-50 Hz
FHD Boiler Feed Multistage Pumps
Nikuni FHD, STW and SNW (2 stage) pumps are ideal for steam boiler and steam generator applications. Nikuni utilizes a fixed impeller on these pumps. Many competitors use a floating impeller, that relies on good hydraulic conditions to balance the impeller centrally. When good conditions are not present (startup, shut-down, open flow, dead head, starved inlet, etc) a floating impeller will wear and ultimately reduce seal life and performance. Nikuni pumps do not have impeller wear and are more efficient because they are closer tolerance to the pump body.
The Nikuni design offers reduced NPSH requirements to 2 meters, and much lower audible noise than competitors. For more information on Nikuni FHD Boiler feed pumps contact Ober-Read & Associates.
Speck manufactures mechanically-sealed regenerative turbine pumps, offered in brass, 316 Stainless and Ryton plastic.
MAX-DRIVE TURBINE PUMPS
Y-MK / LY-MK / NPY-MK / CY-MK Series Pumps
Models: 6 models
Flow: 1/4 – 55 GPM
Mas Shut-Off Head: 300 Feet
Construction: Brass or Ryton (Smallest 2 model), 316 Stainless Steel (All models)
Motor: 1/3 – 7.5 HP, TEFC close-coupled, 1 or 3 phase, 50/60 Hz standard
MAX-DRIVE PUMPS FOR HOT OIL APPLICATIONS
HT and TOE Series Regenerative Turbine Pumps
Models: HT – 3 models, TOE – 3 models
Max Flow: 55 GPM
Max Shut-Off Head: 300 Feet
Max Temp: HT – 350 deg F, TOE – 650 deg F hot oil
Construction: 316 SS (Cast Iron on largest model)
Motor: 7.5 HP max, TEFC close-coupled, 3 phase, 50/60 Hz standard